Delptronics Trigger Man User Manual download pdf (Page 5)

Delptronics Trigger Man Firmware Update Instructions Page 5 of 6

The 5-Pin Header

As you can see in the picture above, the programming

header is 5 pins. Your programmer may have come

with a 6-pin header. The sixth pin is not used. You will

need to snap off the extra pin so that it looks like the

picture to the right.

The pins on the header are designed to be snapped

off. All of the pins are the same, so it does not matter

which end you remove a pin from.

Hold the far right pin with needle nose pliers as

shown. Hold the rest of the pins with your fingers

right up against the pliers. Twist the pliers clockwise

to snap off the extra pin.

1 2 3 4 5 6

No comments

Delptronics Trigger Man User Manual Page 5